10 | ENGLISH
ENGLISH | 11
STEAM MOPPING ACCESSORIES
WARNING: Do not try to connect accessories while unit is emitting steam.
EXTENSION WANDS
1.
Select one of the Extension Wands. Insert end (A) of Wand onto Steam Nozzle (B) with yellow
lock/release button slightly off center with hole. Fully insert and rotate wand slightly to allow
button to snap into hole.
2.
Using the same instruction, attach remaining Extension Wand (C) to the first Wand. Both
Extension Wands should now be connected to the Steam Nozzle.
MOP HEAD
1.
Align Mop Head with open end of Extension Wand, so that hole in Mop Head aligns with
yellow lock/release button on Wand.
2.
Press down on yellow lock/release button. While continuing to hold button down, slide Mop
Head onto Extension Wand (See figure 1-A). Fully insert and rotate wand slightly until button
snaps through hole (See figure 1-B).
NOTE: Do not use excessive force when mopping or using Extension Wands as this
may cause the Wands to break.
BRISTLE BRUSH ATTACHMENT
1.
Align Mop Head with Bristle Brush Attachment, so that the
release tabs (A) on the Bristle Brush align with the sides of the
Mop Head (B).
2. Firmly press the Bristle Brush Attachment onto Mop Head until it
securely snaps into place.
Note: Do not use Bristle Brush Attachment with Microfiber
or Scrubbing Mop Pad.
MICROFIBER PADS
1.
Lay one Microfiber Pad on flat surface, with two fastener strips facing upward.
2.
Align Mop Head with Microfiber Pad. Make sure Mop Head is oriented with Pad as shown,
and centered as best as possible (See figure 2-A).
3.
Press Mop Head firmly down onto Microfiber Pad. Fastener strips will adhere to Pad Grips on
underside of Mop Head. Pad should now be attached and ready for use (See figure 2-B).
CAUTION: Use care when handling a recently used Microfiber Pad, as it may still be hot.
NOTE: Microfiber Pads are machine washable. To avoid picking up lint, washing
separately from other fabrics is recommended. Only use liquid detergent. Avoid using
any fabric softeners or bleach. Air drying is recommended; machine drying on a low
heat or air dry setting is acceptable as well.
The Mop Head and Microfiber Pads are perfect for use on these hard floor surfaces:
IMPORTANT: Do not use on unsealed hardwood or unglazed ceramic surfaces.
Surfaces that are not properly sealed may be warped or damaged by exposure to heat
and moisture.
Care should also be taken when steaming sealed
hardwood floors, as prolonged
exposure to steam in a single spot may cause damage and discoloration. To avoid this,
keep the Mop Head in constant motion on these surfaces.
Steam may remove the sheen from some floors that have been treated with wax.
Extremely rough textured floors may tear or damage Microfiber Pads.
Before steaming any flooring, it is recommended to consult the manufacturer’s
guidelines. For flooring in question, always test on a small inconspicuous area
before proceeding.
A
B
Assembling Your Deluxe Canister
Steam System
FIGURE 2
B
•
Sealed Laminate
•
Linoleum
•
Glazed Ceramic
•
Granite
•
Sealed Hardwood
•
Stained Concrete
•
Marble
•
Vinyl
•
Tile
Assembling Your Deluxe Canister
Steam System
C
A
FIGURE 1
A
B
Summary of Contents for MC1385-AU
Page 12: ......
