14 | ENGLISH
Troubleshooting
Unit fails to heat up.
Steam output is weak or
intermittent.
Excessive amount of water in
steam.
NOTE: Unit produces wet steam
– it is normal for steam to
contain some amount of water.
Unit is not plugged in.
Mineral build-up in unit.
Mineral build-up in unit.
Household circuit breaker / ground
fault interrupter has tripped or
blown a fuse.
Unit is damaged or otherwise in
need of repair.
Water level in Water Reservoir is
running out.
Water Reservoir is empty.
Water condensation in Steam
Hose.
Plug power cord into electrical outlet.
Refer to
Mineral Build-up
section
on Page 13 for cleaning procedure.
Refer to
Mineral Build-up
section
on Page 13 for cleaning procedure.
Reset circuit breaker / ground
fault interrupter, or replace fuse.
If you need assistance, contact a
licensed electrician.
Immediately cease usage and
unplug. Contact Consumer
Service for further assistance
(see Page 16 for details).
Refer to
Filling Water Reservoir
procedure on Page 11.
Refer to
Filling Water Reservoir
procedure on Page 11.
Point nozzle towards sink, tub or
ground and shake while pressing
Steam Trigger. Continue until
excess water is released.
PROBLEM
POSSIBLE CAUSE
SOLUTION
Accessories do not stay firmly
connected to Steam nozzle.
Accessories not properly installed. Check to make sure that acces-
sories are properly connected, per
procedures on Pages 8-10.
No steam but can hear pump.
Water Treatment Cartridge is dry.
Allow pump to prime water
through it.
Allow Water Treatment Cartridge
to soak in water for one minute
before installing into unit.
Summary of Contents for MC1350
Page 50: ...50 ENGLISH...
Page 51: ...ENGLISH 51...
