ASSEMBLING AND ADJUSTMENTS
6 – English
General
Handle
Assembly
1
Put the stay into the lower handle.
2
Position the lower handle in the recesses on the
cutting cover.
3
Press in the plastic plugs on both sides.
4
Position the stay in the groove on the cutting deck.
5
Assemble the two stop lugs that lock the stay and the
handle in place. There are two stop lugs, one marked
H and one V. Place the lug marked ”H” on the right-
hand side and the one marked ”V” on the left-hand
side.
Top handle
1
Place the handlebar’s tubular construction in direct
opposite to the lower part of the handlebar. Tighten
the knobs properly.
Cutting height
Cutting height is adjusted individually for each wheel.
Press out the shaft and move to the desired position.
Filling with oil
•
The oil tank is empty at delivery. Fill the oil slowly. See
instructions under the heading Maintenance. The
engine oil should be changed the first time after 5
hours running time.
!
IMPORTANT! Prevent unintentional
starting by removing the ignition cable
from the spark plug.
IMPORTANT! Both stop lugs for the handle must be
assembled before the machine is used. Press in the
lugs firmly.
NOTICE! Do not set the cutting height too low as there
is a risk that the cutters might hit ground with
unevenness.
