McCulloch 32CC TRIMMER, Service Manual, Page: 4 / 18

McCulloch 32cc Trimmer
2
2.6. Align the arrows on the spool with the arrows on
the housing. See Figure 2.6.
2.7. Insert a length of trimmer line through each eye-
let. There are two sheaves for line in the spool,
separated by a narrow groove. The line must
enter the narrow groove. See Figure 2.7.
2.8. From the eyelet, the line will be channeled up
under the bump knob by a set of ramps in the
spool. See Figure 2.8.
2.9. The ends of the line are looped-through the
anchors to hold them in place, then pulled-tight.
NOTE: With the arrows aligned, the line can also
be installed from the inside-out, by removing the
bump knob.
2.10. The final step is to rotate the spool in the direc-
tion indicated by the arrows, drawing the line into
the head. See Figure 2.10.
2.11. Stop winding when each end of the line is about
6” long.
2.12. Press the bump knob and pull on the line to
manually test the trimmer head. Do not push the
housing off it’s seat while testing.
Figure 2.6
Housing
Spool
Arrows
(marked for
clarity)
Figure 2.7
Eyelet
Center
groove
Figure 2.8
Ramps
Bump knob
removed for
clarity
Bump knob
Anchors
Figure 2.10
Inset: arrow on spool, marked
for clarity