background image

4

The Sling Shot RTR comes in three different colors.  Each color represents the frequency (or channel number) that the radio control
system operates on.  The Sling Shot RTR radio control system operates on 27Mhz.  The 27Mhz frequency band is shared between
model cars and boats, so check the frequency if others are in the area before turning on the transmitter or boat.  No two models can operate
near each other if they are on the same frequency.

BECOMING FAMILIAR WITH YOUR SLING SHOT RTR

Battery Cover:

  This cover houses the 6 AA Alkaline batteries that power the

transmitter.

On/Off Switch:

  Turns the transmitter on and off.  Two LEDs show the power

status of the batteries.

Trim Levers:

  These levers, one for turning and one for throttle control, allow you

to fine tune the center positions of the throttle lever and the right/left turn lever.

Antenna: 

 Transmits the signal from the transmitter to the receiver inside the boat.

Right/Left Turn Lever:

  Used to steer the boat.  Pushing the lever left or right causes the boat to turn left or right.

Throttle Lever:

  Used to control the forward speed of the boat.

Power LEDs:

  Shows the condition of the transmitter batteries.  Both LEDs glow when the batteries are good.  When only the red LED

glows, the batteries should be replaced.

Transmitter Handle:

  Molded into the transmitter case to give you a convenient way to carry the transmitter.

Radio control systems

operating on 27Mhz are

licensed to operate

surface vehicles only.

Channel #

Frequency

Boat Color

01

26.995

Purple

04

27.145

Yellow

05

27.195

Silver

27Mhz

Main Hull:

  The main body of the boat.  The hull is molded from lightweight, high-strength plastic.

Electric Motor:

  Provides power to the boat.  The Sling Shot RTR features a powerful "Black Can" 380-size motor to reach high speeds.

Antenna:

  Receives the signals from the transmitter.  Never cut the antenna shorter or you'll loose control of the boat after a very short

distance.

Rubber Hatch Cover:

  The rubber hatch cover prevents water from getting into the hull.  Remove the rubber hatch cover to install the

battery into the hull and to turn the boat on and off.

On/Off Switch:

  Turns the electronics inside the boat on and off.

Propeller: 

 The propeller is attached to the drive shaft.  When spinning, the propeller creates thrust which pushes the boat forward.

Rudder:

  The rudder pivots to make the boat turn left and right.

The 6 cell NiMH battery included with your
Sling Shot RTR comes from the factory
partially charged.

DO NOT CHARGE THE BATTERY UNTIL
AFTER TESTING THE MOTOR AND
STEERING CONTROLS.

This will ensure that the battery is run down
completely before recharging it.  This is
important to ensure that the battery receives
a full charge and is cycled before you first run
your Sling Shot RTR.

BATTERY TIP

Summary of Contents for Sling shot













Reviews: