Need help or have any questions? Call us at 1-714-963-0329 or send us an email to [email protected]
6
PUT IT TOGETHER !
Step 1: Boat / Radio Batteries
Boat Battery
Locate the
battery pack
and the
battery charger
.
Attach the charger clips to your car battery, making
sure to attach the RED clip onto the POSITIVE (RED
or +) side of the battery and the BLACK clip to the
NEGATIVE (BLACK or -) side of the battery. and
then plug the battery connector into the charger.
Plug the boat battery and charger connectors to-
gether. Rotate the dial to the full (30 minute) charg-
ing position and set the battery away from the car
engine if warm. Don’t worry, the charger has a built-
in 30 minute timer so you can’t over-charge the bat-
tery.
When it’s finished charging, disconnect the boat bat-
tery and remove the charger clips from the car .
Radio Transmitter
Locate the
transmitter
and your AA Alkaline
batter-
ies
. Remove the transmitter’s front cover by pushing
down at the arrow molded on the plastic and sliding
the cover off. Slide out the battery holder, being
careful
not
to disconnect the wire.
Load your Alkaline batteries into the battery holder,
being very careful to put each of the batteries in the
right way, as marked inside the compartments. Slide
the battery holder back into position, being careful
not
to pinch the wire or loosen the connector.
Replace the transmitter front cover and snap it
closed
Turn on the transmitter power switch and verify that
the power lights come on. Then turn the switch off. If
the battery lights do not come on, open the transmit-
ter up again and put the Alkaline batteries in the cor-
rect way before proceeding.
