Page 19
Alterations reserved
Operating Manual
Stand 01/2004
SAP 46 L ENG
5.4
Pressing unit
Adjust the pre-pressing rollers 1 by
inserting a paper strip into the setting
element 2. This paper strip should
normally cover the full product thickness.
The setting of the main pressing rollers
3 occurs by inserting a paper strip
of approximately ¾ of the product
thickness into the setting element 4.
For opening of the setting element 4,
turn the setting key 5 left, and for
closing turn the setting key to the right.
If a product that is too thick reaches
the pressing rollers the machine will
be disconnected by the micro switch 7.
5.5
Sheet transportation
5.5.1
Sheet control
During set-up work or during production,
single sheets may be taken before they
enter the machine.
For this purpose, rotate the rake 1
downwards by means of the ball grip 2.
The sheet will run on the rake and may
be taken off without any danger.
