FUNK CROSS
USER MANUAL
p.16
3.5.9 Error codes
In the event of a malfunction, the display automatically shows a 4-character code corresponding to the fault encoun-
tered. Error codes are displayed on the right side of the display and highlighted by an exclamation mark. To remove the
code, turn the device off and on again.
CODICE ERRORE
DESCRIZIONE
0001
PROBLEM COMMUNICATING WITH BATTERY. BATTERY STATUS DATA MAY BE DISPLAYED INACCURATELY. CHECK THAT THE WIRING AND CONTACTS OF THE
BATTERY ARE CONNECTED CORRECTLY AND INTACT.
0101
COMMUNICATION PROBLEMS BETWEEN THE TRANSMISSION UNIT AND THE GRAPHICAL INTERFACE.
CHECK THAT THE WIRING IS INTACT AND CONNECTED CORRECTLY.
0104
SPEED SENSOR NOT DETECTED.
CHECK THAT THE SPEED SENSOR AND MAGNET ARE CORRECTLY ALIGNED.
CHECK THAT THE SENSOR IS INSTALLED AND CONNECTED CORRECTLY.
0105
PROBLEMS WITH THE TORQUE SENSOR SIGNAL. THE TORQUE SENSOR SIGNAL IS FAULTY. THE ENGINE WILL RUN AT REDUCED POWER.
3.5.8 Battery indicators
The state of charge of the battery (Ref.1 - Fig. 7) is indicated on the left side of the display.
When the battery is fully charged, 5 bars appear on the display; the bars gradually decrease as the battery discharges.
When the battery charge is low, the last bar flashes to warn you that the battery needs to be recharged.
ATTENTION
Depending on the type of failure, the sys-
tem may prevent the engine from
starting or running at maximum power.
