6.4
The "Ready" LED turns on and the number of the finished cards of the last job
appears in the Display after all errors are cleared.
6.5
Press the Counter Reset button (for a couple of seconds) to reset the number.
6.6
To select Cutting modes
A green LED indicates the present Cutting mode. The mode used for the last job
is the default. Press the "A" or "L" buttons to select your desired mode.
Note:
�
The 3 modes for A4-sized paper can be selected when a Slitter Unit for
the A4-sized is attached.
�
The 2 modes for Letter-sized paper can be selected when a Slitter Unit
for the Letter-sized is attached.
�
"E003" appears in the Display with no Slitter Unit being attached.
6.7
To select the Cutting Mark function
To use the Cutting Mark function, you have to print a "Cutting Mark" on your
business card layout at the same time. The Cutting Mark is a black rectangle,
which size is 2mm x 31mm (0.08" x 1.22"), to tell the machine where to start
cuttings.
�
Press the Cutting mark button to turn on the Cutting Mark function (The red
LED turns on).
�
Press the Cutting mark button again to turn off the Cutting Mark function.
Paper Feed Direction
31mm / 1.22"
2mm / 0.08"
3mm / 0.12"
While the Cutting Mark function is on, the system starts cutting at the line which
is 3mm behind the lead edge of the Cutting Mark. Manually-set Top Margin
length is ignored. The resulting cuts (2nd, 3rd, 4th...) are done according to the
selected Cutting mode's layout pattern (See page 12 to 13).
16
http://www.monomachines.com/
http://www.monomachines.com/
