4
D
ESIGN
F
EATURES
1.
Gain Adjuster – These can be adjusted to match output levels from a variety of source units individually
for the left and right inputs.
2.
Crossover Multiplier Range Switch – Used to set the multiplier for the left and right crossover
frequencies between x1 and x10. A setting of x1 leaves the adjustable crossover frequency from
50-500Hz. A setting of x10 changes the adjustable crossover frequency to 500-5KHz (5000Hz)
3.
Crossover Frequency Adjuster– Used to adjust the left and right crossover frequency. Variable from 50Hz
to 500Hz in x1 mode, and 500-5KHz in x10 mode.
4.
Crossover Type – Is used for selecting High-Pass Filter (HPF) or Low-Pass Filter (LPF) operation for the left
and right speaker outputs.
5.
Crossover Filter Switch – Off sets the crossover to all-pass, adjustments to the crossover range, freq, and
type are bypassed. On allows adjustments to the crossover settings to be used.
6.
Front End Defeat – Used to reroute the input signal around the signal processing circuitry within the
amplifier. While in the ON position, all gain and crossover functions are bypassed.
7.
Clipping LED Indicators – These Yellow LEDs illuminate if clipping is detected for either the left or right
speaker outputs.
8.
Power LED – This Green LED illuminates when the unit is turned on.
9.
Protect LED – This Red LED illuminates if a short circuit or too low of an impedance is detected at the
speaker connections or if the amplifier reaches thermal protection. The amplifier will automatically shut
down if this occurs.
Controls
Summary of Contents for RAA2400
Page 1: ...R E F E R E N C E...
