LED-ILLUMINATION
The
MB QUART PREMIUM
Subwoofer Boxes have an integrated LED Illumination System. This illumination is only allowed to light up, if the vehicle
is not in driving condition. It is recommended to switch the illumination with the vehicle's trunk illumination. To power-up the LED-System, use
the supplied wiring harness, which should be plugged into the integrated socket (12V DC) of the speaker terminal. Connect the marked “Plus” cable
with the +12 volts line and the marked “Minus” cable with the ground line of the vehicle´s trunk illumination. Please ensure that the connection
of the cables have the correct polarity as marked.
INTERCONNECTION
• Ensure always correct polarity for all connections during the installation of the sound system.
• Please use only appropriate speaker cables for the connection of the subbox system.
• Never connect the minus-pole of the speaker terminal with the negative ground of the vehicle’s chassis.
• Attend by any means the total speaker load impedance, which will be connected to the amplifier and also the maximum power load,
like described on the last page.
• Attend also while installing the subbox system the informations of your amplifier’s manual.
SERIAL-MODE (8 Ohm Load)
Speaker
Terminal 2
Speaker
Terminal 1
PARALLEL-MODE (2 Ohm Load)
DUAL-MODE (2 x 4 Ohm Load)
12 V DC
Speaker
Terminal 2
Speaker
Terminal 1
STANDARD-MODE (4 Ohm Load)
12V
Terminal
12V
Terminal
PHG304D
PHG304S
LED-Illumination
12 V DC
LED-Illumination
Speaker
Terminal 2
Speaker
Terminal 1
Speaker
Terminal 1
P H G 3 0 4 D
·
P H G 3 0 4 S
ENG
