9
For additional technical information
, go to the “SUPPORT” tab at MBQUART.com
There you will find helpful, FAQ, TEQ Tips and you can contact Technical Support via email.
©2018 Maxxsonics USA
PREPARATION
If your subwoofer was not preinstalled, you will wire the woofer with the dual voice coils to 2
ohms (indicated with the
Ω symbol) as pictured in FIG 3-2. We have prepared the internal
harness so you cannot make a mistake. Wiring the subwoofer for 2 ohms (2
Ω) will allow the
subwoofer to develop maxximum power from the amplifier by perfectly balancing the impedance
with the amplifiers power output.
(FIG 3-2)
Use the connection where two wires will insert into one voice coil connector and then route the
other end of the wire to opposite connector, shown in FIG 3-3 and FIG 3-4.
NOTE
– Wiring code is solid white connects to the (+) Red terminal
and White/Black Stripe connects to the (-) Negative
To open the terminals push down on the connector to open, push the soldered ends through the
hole and release the connector to establish a good electrical connection.
