3
CENTER FREQUENCY: This knob allows you to select the frequency you want the MBC1
bass restoration circuit to maxximize.
FREQUENCY RANGE: This knob allows for you to adjust the range of frequencies from your
center point. All the way to the left will include the maxximum frequencies to maxximize, while
all the way to the right will enhance only a limited amount f frequencies near your CENTER
FREQUENCY.
OUTPUT LEVEL CONTROL: This knob allows for you to control the amount of signal voltage
you are sending through the RCA OUTPUTS to your amplifier(s). It is important to note that the
MBC1 has a built in line driver capable of sending an ‘ultra clean’ 9 volts of signal output to
your amplifier(s).
Be sure to reference
the end panel silk screening for GAIN/LEVEL
CONTROL on your amplifier(s). Some amplifiers cannot handle the full 9 volts and going
beyond the specified Input range on your amplifier(s) can be damaging.
GROUND ISOLATION: Occasionally alternator whine may appear in the system because the
source unit and amplifier may use different grounds. To help in this situation, we have provided
alternative grounding options.
MAKE SURE THE SYSTEM IS OFF BEFORE SWITCHING
THIS SELECTION!
RCA INPUT: In most cases you will leave the selection switch in the BALANCED position. In
some systems the source unit may look for a ground through the RCA connections. In this
event you would switch the selection to UNBALANCED.
INPUT: RCA’s from source unit connect to this location.
OUTPUT: RCA’s from the MBC1 connect to the inputs of your amplifier(s).
REMOTE: The BPR-1 Bass Processor Remote dash mount control connects here. This
remote allows for complete control of your audible subwoofer level along with a LED indicator
which brightens as you increase bass enhancement.
REM / 12V / GND:
-REM: Connects to a 12V+ switched source. The REM cable should have 12V when the
source unit is on and 0V when the source unit is off. Typically this would connect to
the ‘Power Antenna’ output wire on the back of your source units’ wiring harness.
-12V: Connects to a 12V constant source. The Positive battery terminal is recommended and a
1 amp in-line fuse is required.
-GND: Connects to a ground location. Be sure that all paint is removed from the area of this
connection on the vehicle chassis.
