15
FRONT SPEAKER INSTALLATION
This section covers final installation of the passenger’s side front speaker panel and temporary installation of
the driver’s side speaker panel. Final installation of the driver’s side speaker panel occurs after the system is
tested and gone through a thorough inspection prior to reassembly.
FRONT SPEAKERS
2
3
Locate the factory front left
and right speaker panels and
identify two mounting clip
retainers and washers that
need to be removed on each.
From bottom side, gently
remove mounting clip retainers
as indicated. This can be done
with your fingers. Do this for
both passenger and driver side.
Replace these mounting clip
retainers and washers in the
same locations of both MB
Quart speaker panels in your
Can-Am X3 kit. It’s a direct fit.
5
6
Connect passenger side
speaker to gray wiring routed
earlier to speaker area. Red/
black wires are for optional
illuminated speaker rings.
Begin to set passenger side
speaker panel in place by
loading the edge nearest the
center with the clip retainers
into position as shown.
Pull center edge of panel up to
align clips with the respective
dash receiver holes. This is
a crucial step to facilitate the
correct overall panel fit.
7
8
Next, drop the speaker edge of
panel into place*. Attach lowest
T-30 screw into place to allow
check of final panel fit and to
ensure all clip holes align.
Secure the front speaker panel
by reinstalling all the remaining
clips and hardware in the same
locations removed during the
disassembly process.
*AFTERMARKET ROLL CAGES
Although MB Quart front speakers
come pre-installed in the Can-Am
replacement panels, they may
require removal from the panel to
fit low-slung aftermarket roll cages
that fit close to the hood area.
In these cases where fit is tight or
would damage the speaker due to
the roll cage position, remove the
speaker from the panel first, install
the panel in the vehicle, then
connect and install the speaker
into the panel.
1
4
Identify
Two Clip
Retainers
Gently
Compress to
Remove
Clip Retainers
Installed in Panel
● SOLID GRAY - Right Front Speaker (+)
● GRAY/BLACK - Right Front Speaker (-)
Drop Panel into Place &
Attach Lower T-30 to Secure
& Adjust Panel Fit
T-30 + 10mm
Clips
Clips
