7
6
Mo
ist
ur
e Se
nsi
ng
Irr
iga
tio
n K
it
15 min
SIMPLE INSTALLATION
STEP 1
Unscrew the green watering
head and place the ceramic
sensor in the water for at least
15 minutes.
Then screw back together
un-
derwater,
tightening firmly
down to the ring (A). The sensor
must be completely filled with
water.
Now that the Watering Sensor
is filled with water and screwed
back together, leave it in the
water for at least another 15
minutes.
STEP 2
STEP 3
15 min
A
Insert the Watering Sensor in the soil near the roots, pushing
it down to the depth indicated
(B)
and leaving a gap of about
20 to 25 cm between each Watering Sensor. Make sure it is
firmly anchored in the earth. Put the Watering Sensor with
the end-piece
(D)
at the end of the installation. If necessary,
take off the T-piece
(C)
and replace it with the end-piece
(D)
.
STEP 4
B
C
D
CONNECTION TO THE
FEEDING TUBE
Take the feeding tube and cut off
pieces of the appropriate length and
use them to connect the individual
Watering Sensor inserts. Take the
tube pieces and push them firmly
onto the T-pieces of the Watering
Sensors. Make sure the tube is firm-
ly in place.
Do not use lubricants
(grease, soap, etc.) when pushing
on the pieces!
STEP 5
IMPORTANT
:
It is essential to water the soil several times
before fitting the individual Watering Sensors.
Summary of Contents for Moisture Sensing Irrigation Kit
Page 1: ...INSTRUCTIONS EN Moisture Sensing Irrigation Kit...
Page 8: ......
