4
１．
Remove the splash shield installation bolt A (2), fastener B (1)
and bolt C (1).
２．
Pull the splash shield inward and disengage the tabs
(7 locations), and then remove the splash shield.
３.
Cut off the splash shield shown in the figure using nipper
(2 locations).
４.
Align the rear bumper holes, and install the kit clip nuts (3).
3
．
MUD FLAP (REAR) INSTALLATION
•
The removed bolt A (2), fastener B (1) and bolt C (1) are to
be reused. Be careful not to damage or lose them
CAUTION
•
The figure shows the left side, however, perform the same procedure for the right side.
NOTE
Bolt A
Bolt C
Fastener B
Splash shield
Splash shield
Tab
Splash shield
Cut out
Rear bumper
Clip nut
