Maytech Waterproof Remote Control User Manual_20191012 by Eric and Eileen
15 / 17
1. If remote and receiver are paired successfully before, then no need to pair them again.
2. If remote and receiver does not get paired before, please pair them according to below steps:
1) Turn off receiver.
2) Select
【
>4.Pair
】
and long press function button for 1 second to enter pair status. When screen shows
【
Paring…
】
, turn on receiver and it will auto-pair with remote control in 0.5 second. Red led lights steady.
Pairing competed. Remote screen will automatically return to main menu.
If auto-pairing time is over 1 second and screen still shows
【
Pairing…
】
, pairing fails and it needs to turn off
and turn on receiver again to pair them. If you don’t want to continue the pairing process, long press function
button to exit to main menu.
19.5 Calibration
Due to environmental changes during use, remote calibration may be out of proportion to the output of PWM
signal. Then it needs to do calibration.
Select
【
>5.Calibration
】
and long press function button for 1 second to enter Sub-menu.
Once enter
calibration, it must need to be finished.
If don’t continue calibration and exit, remote and receiver will stop
working together.
Press throttle trigger to top and loose it. Then press brake trigger to top and loose. When press trigger, the
screen will prompt
【
Calibrating
】
and
【
Cal. OK
】
.
After both two are
【
Cal. OK
】
, long press function button to return to main menu and save the results.
19.6 Speed Source
This is an important parameter. If you want to show RPM or Speed&Distance in Esurf or Esk8 mode, please
select suitable speed source in here.
Select
【
>6.Speed Source
】
and long press function button for 1 second to enter Sub-menu.
【
No Source
】
No speed source, remote screen will not display any information of RPM/Distance/Voltage/
Current/Temperature.
【
Hall Sensor
】
The motor ERPM is detected by the state change of the Hall sensor.
【
Motor Wire
】
The motor ERPM is detected by the motor phase wire back electromotive force.
【
VESC
】
Read all kinds of valid data from VESC through UART port.
Default: No Source.
19.7 Motor Poles (Motor pole pairs)
Be sure to note that the “Poles” here are actually Pole Pairs! This data is used to calculate motor speed(or
RPM) based on motor ERPM, please refer to “Item 10”.
Press function button to add pole pairs number. Max number is 24.
Press brake trigger to save number and return to main menu.
