For pullout drawer only:
1. Turn both stabilizing
legs clockwise until
firmly against floor.
Turn roller adjustment
screws 2 to 3 times
counterclockwise so that the full weight of
refrigerator rests on stabilizing legs.
2. Replace toe grille and bracket cover(s). See
markings on inside of toe grille to insure proper
placement.
Roller Adjustment Screw
Stabilizing
Leg
4
Installation
Notch
Location
• Use slight pressure to pry the
cover loose.
• Continue to maintain
downward pressure to the
notched side of the cover while
swinging it off.
C
C
A B
A
B
4. Select models also have rear adjustment screws
(B). Using the hex head driver, turn each of these
adjustment screws (B) to raise or lower the rear of
the refrigerator.
5. Using the carpenter’s level, make sure front of
refrigerator is 6 mm or half bubble higher than
back of refrigerator and that the refrigerator is level
from side to side.
6. Turn stabilizing legs (C) clockwise until firmly
against floor.
7.
Freezer drawer models only:
Turn adjustment
screws (A) counterclockwise to allow the full
weight of the refrigerator to rest on the stabilizing
legs.
8. Replace bracket cover(s).
• Position cover into the outer edge of the hinge.
• Swing the cover toward the cabinet and snap it
into place.
9. Replace the toe grille.
Note
• For proper reinstallation, ensure the “top” marking
on the interior of the toe grille is oriented correctly.
• Align the toe grille mounting clips with the lower
cabinet slots.
•
Snap bottom portion into place first.
Press
down on top of grille until top portion snaps into
place.
Note
• Some models only have adjustment screws “A.”
3. Using hex head driver, turn the front adjustment
screws (A) on each side to raise or lower the front
of the refrigerator.
Handles
If not installed, the handle is located in the interior of
the fresh food section or attached to the back of your
refrigerator.
Remove and discard handle packaging and tape.
Handle design varies from refrigerator to refrigerator.
Please reference the appropriate instructions for your
model below.
Fresh Food Handles
Front Mount Handle - Style 1
Materials Needed
• Phillips screwdriver
•
5
⁄
16
" hex head driver
To Install:
1. Remove 0.6 cm hex head screws
from door face with hex head driver,
and Phillips screw from top of door.
• If reversing door, remove door
plugs from opposite side of door
and insert in screw holes.
2. Align handle holes with screw holes on
door face and secure with two door face
screws from step 1.
2. Remove bottom bracket cover(s).
• Place the eraser end of a pencil or similar blunt
tool in the cover notch.
