Maytag Neptune MAH9700, Technical Training Manual

Page: 47 / 52

41
Slide 104
Service Mode
This mode provides Service Personnel the ability to verify the operation of the dryer.
The Service Mode can be implemented at any time, including the middle of a dry cycle.
While in the Service Mode, the Technician can start special diagnostic tests such as a
System Check Mode, LED Switch/Check, Display Software version number and display
diagnostic/help code listings.
Slide 105
Enter Service Mode:
Dryer must be on before Service Mode can be entered. Press Chime
and Temperature Keys for 3 seconds, or until 3 beeps are heard. The
machine will now be in Service Mode. Upon entry into Service Mode,
the Sensor Bar Touch
Data is to be displayed.
Exit Service Mode
Press the OFF key to exit Service Mode or repeat the Chime and
Temperature sequence.
Service Mode
Press and hold for 3 Sec.
Refer to Technical Data Sheet for Detailed Instructions
Slide 106
System Check
Press and hold for 3 Sec.
Refer to Technical Data Sheet for Detailed Instructions
System Check Mode
While in Service Mode, pressing the Time and Wrinkle
Prevent keys for 3 seconds, will put the dryer into the
System Check mode and " in " will display. The following
table lists the various functions based on the keys being
pressed