8
DRAIN SYSTEM
ELECTRICAL REQUIREMENTS
n
A 220-240 volt, 50 Hz., AC only, 10-amp, fused electric supply is
required. A time-delay fuse or circuit breaker is recommended. It
is recommended that a separate circuit serving only this appliance
be provided.
n
After installation, access to mains plug or disconnection from
mains supply via a double-pole switch, must be ensured at all
times in order to ensure immediate deactivation of the washer
in case of emergency.
n
This washer is equipped with a power supply cord having an
earthing plug. The plug should be accessible for disconnection
from the supply.
n
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent, or similarly qualified persons
in order to avoid a hazard.
Drain system can be installed using a floor drain, wall standpipe,
floor standpipe, or laundry tub. Select method you need.
Floor standpipe drain system
Minimum diameter for a standpipe drain: 51 mm (2"). Minimum
carry-away capacity: 38 L (10 gal.) per minute. Top of standpipe
must be at least 990 mm (39") high; install no higher than
2.44 m (96") from bottom of washer.
Laundry tub drain system
990 mm
(39")
114 mm
(4,5")
990 mm
(39")
114 mm
(4,5")
Wall standpipe drain system
710 mm
(28")
See requirements for floor standpipe drain system.
Floor drain system
Floor drain system requires a Siphon Break Kit (Part Number
285834). Minimum siphon break: 710 mm (28") from bottom
of washer. Additional hoses may be needed.
.
.
114 mm
(4,5")
.
Summary of Contents for MVW18CS
Page 3: ...3 WASHER SAFETY ...
Page 21: ...21 SÉCURITÉ DU LAVE LINGE ...
Page 40: ...40 SEGURIDAD DE LA LAVADORA ...
Page 58: ...58 SICUREZZA DELLA LAVATRICE ...
