Maytag MLG34 Installation & Operator'S Manual Download Page 3

113497 - 1

Maytag Co.

3

IMPORTANT

You must disconnect and lockout the electric
supply and the gas supply before any covers or
guards are removed from the machine to allow
access for cleaning, adjusting, installation, or
testing of any equipment per OSHA standards.

Please observe all safety precautions displayed
on the equipment and/or specified in the installation
manual included with the dryer.

Before installation, check that the local distribution
conditions, nature of gas and pressure, and
adjustment of the appliances are compatible.

CAUTION

Dryer(s) should never be left unattended while in
operation.

“Caution: Label all wires prior to disconnection
when servicing controls.  Wiring errors can cause
improper operation.”

«Attention: Au moment de l’entretien des
commandes, étiquetez tous les fils avant de les
débrancher.  Des erreurs de câblage peuvent
entraîner un fonctionnement inadéquat et
dangereux.»

WARNING

Children should not be allowed to play on or near
the dryer(s).  Children should be supervised if near
dryer(s) in operation.

Under no circumstances should the dryer door
switch(es), lint door/drawer switch(es), or heat
safety circuit(s) ever be disabled.

The dryer must never be operated with any of the
back guards, outer tops, or service panels
removed.  Personal injury or fire could result.

The dryer must never be operated without the lint
filter/screen in place, even if an external lint
collection system is used.

If a hi-limit switch trips, a service call is required to
investigate the reason and resolve the issue.

FOR YOUR SAFETY

Do not dry mop heads in the dryer.  Do not use
dryer in the presence of dry cleaning fumes.

The dryers must not be installed or stored in an
area where it will be exposed to water and/or
weather.

The wiring diagram for the dryer is located behind
the control panel.

Table of Contents _____________________

List of Acronyms _____________________

HVAC

Heating, Ventilating, and Air-Conditioning

in WC

Inches of Water Column

L.C.D.

Liquid Crystal Display

L.P.

Liquid Propane

OSHA

Occupational Safety and Health Administration

UL

Underwriters Laboratory

State of California Proposition 65 Warnings:

WARNING: 

This product contains a chemical

known to the State of California to cause cancer.

WARNING: 

This product contains a chemical

known to the State of California to cause birth
defects or other reproductive harm.

In the State of Massachusetts, the following
installation instructions apply:

Installations and repairs must be performed
by a qualified or licensed contractor,
plumber, or gasfitter qualified or licensed by
the State of Massachusetts.

If using a ball valve, it shall be a T-handle
type.

A flexible gas connector, when used, must
not exceed 3 feet.

Safety Precautions ..................................... 4
Specifications ............................................. 6
Installation Procedures .............................. 8

Location Requirements ................................................. 8

Unpacking/Setting Up .................................................... 8

Dryer Enclosure Requirements ..................................... 8

Fresh Air Supply Requirements .................................... 9

Exhaust Requirements .................................................. 9

Electrical Information ................................................... 11

Gas Information ........................................................... 12

Converting from One Family of Gas to Another .......... 15

Gas Pressure Testing .................................................. 17

Preparation for Operation/Start-Up ............................. 17

Preoperational Test ...................................................... 18

Preoperational Instructions ......................................... 18

Shutdown Instructions ................................................. 18

Service/Parts Information ........................ 18

Service ......................................................................... 18

Parts ............................................................................. 18

Warranty Information ............................... 19

Warranty ...................................................................... 19

Routine Maintenance................................ 19

Cleaning ....................................................................... 19

Adjustments ................................................................. 19

Data Label Information............................. 20

Summary of Contents for MLG34























Reviews: