Maytag CWG3100AA Series, Service Manual

Page: 15 / 35

©2005 Maytag Services
16026549 15
To avoid risk of electrical shock, personal injury or
death; disconnect power and gas before servicing,
unless testing requires power and/or gas.
Disassembly Procedures
5. Lower and remove control panel assembly and
backing plate.
6. Remove screws securing clock (and overlay) to
control panel and backing plate.
7. Reverse procedures to reassemble.
Oven Light
Switch
Vent Extrusion
Control Panel
Backing Plate
Rear Cover
Clock w/Overlay
Wire Cover
Top, Front Extrusion
Control Panel Assembly
Oven Light Assembly
Oven Light Bulb/Oven Light Socket
1. Remove power from unit (at the circuit breaker).
2. Open oven door and remove oven racks.
3. Hold lamp cover in place, and slide retaining wire off
cover.
Lamp
(40 watts)
Lamp
Socket
Retaining Clip
Retaining Clip
Lamp
Cover
Lamp and Socket
NOTE: Cover will fall if not held in place when removing
retaining wire.
4. Unscrew lamp and remove.
5. Gently pry retaining clips inward towards center of
socket.
6. Once retaining clips are released, gently pull socket
into oven cavity.
7. Label and disconnect wire terminal connections and
remove socket.
8. Reverse procedure to reassemble.
NOTE: Reposition fiberglass insulation around oven
light socket to eliminate possibility of heat
related problems.
Replacing Shut-off Valve (CWG3100AA*)
1. Remove oven bottom, see "Removing Oven Bottom"
procedure.
2. Remove screws securing oven valve cover.
3. Disconnect gas supply lines from valve.
4. Disconnect screws securing valve to support
brackets.
5. Slide valve out to remove.
6. Reverse procedures to reassemble.
Replacing Burner Fitting (CWG3600AA*)
1. Remove oven burner, see "Replacing Oven Burner"
procedure (do not perform step 2).
2. Disconnect gas lines from burner fitting.
3. Remove screws securing burner fitting to support
bracket.
4. Slide burner fitting out to remove
5. Reverse procedures to reassemble.
Oven Burner
Ignitor
Pressure Regulator
and Support Bracket
Shut-off Valve
and Support Bracket
Gas Tubing
Oven Valve
Cover
Model CWG3100AA* Gas Controls
Replacing Rocker (Oven Light) Switch
1. Remove control panel assembly, see "Replacing
Control Panel Assembly" procedure.
2. Label and disconnect wire terminals from rocker
switch.
3. Squeeze tabs on rocker switch and push outward to
remove.
4. Reverse procedures to reassemble.
Replacing Control Panel Assembly
1. Remove power from unit (at the circuit breaker).
2. Remove screws securing rear cover and remove.
3. Remove screws securing wire cover and remove.
4. Remove screws securing control panel assembly.