MAYSER RADIOBAND 3G, User Manual, Page: 13 / 24

PROGRAMMING
4 Programming
 Working with one safety edge, it must be connected to IN1 of the transmitter. IN2
does not work.
This band can work on R1 (mode 1) or R2 (mode 2) or simultaneously on the 2
relays (mode 3).

Working with two safety edges (mode 4), the safety edge connected to IN1 act on
R1 and the safety edge IN2 connected on R2.
In IN2 only mechanical band / contact or 8k2 band is allowed.
Before programming, place the options selectors at the desired position. Any subsequent
change will require a receiver reset and reprogramming.
Press the PROG button and hold it until the desired mode is selected. LED's for R1 & R2
will flash in sequence to select the correct operation mode.
There are four programming modes , depending on the inputs you wish to use of
the transmitter and the outputs required to activate on the receiver.
The equipment remains in programming mode during 60s before programming the first
transmitter, and then 20s more for each of the following transmitters.
UM_320XXXX_RB3SYSTEM_EN_MAYSER_Rev00 Página 13/24