1. Place each Lift Actuator Column Assembly (1) upside
down with the cord toward the floor. CAUTION: Do not
pinch Cord Assembly
2. Position the XR Foot (2) over Lift Actuator Column
Assembly (1) with the longer portion of the Foot toward
the front. The column front is determined by the
position of the cross channel clip welded on the column.
Position this clip to the rear.
3. Attach the XR Foot (2) to the Lift Actuator Column
Assembly (1) with four M6 x 16 mm Screws (E1) and
Star Washers (E2).
4. Place the assembled columns upright and attach the
Cross Channel (3). Position the Cross Channel flange
with end notches toward the floor. Slide the Cross
Channel bracket onto the tapered channel clip on each
Column. Gently tap the Cross Channel in place with a
Rubber Mallet to assure a tight fit.
5. In the event that you must reposition the Actuator
Cord. Gently remove the cord and strain relief from the
notch in the top of the Lift Actuator Column Assembly
(1). Position the cords so that they are toward the
center of the assembled base. Insert the strain relief
into the appropriate Column notch. Attach Top Plate
(4) to each Actuator Column with four M6 x 16 mm
Screws (E1) and Star Washers (E2).
6. Attach the Memory Switch (6), Main Cord (7), and the
39.37 Cables (8) to the Control Box (5).
7. Attach Anti Collision Dongle Option (when ordered).
To install the Anti Collision Dongle (9), simply plug the
dongle into one of the two control ports on the Control
Box (5). The function is only active when the dongle is
mounted - if you remove the dongle you disable the
function.
Note: Situations where anti-collision does not work.
1) If the collision happens during the initialization stage.
2) If the collision happens within the first 1000 msec or
after the control button has been released.
3) If the collision time span is too long, i.e. if the collision
is with a soft object.
Cross Channel
notches DOWN
Cords toward
center
Cord Assembly
Cross Channel clip
on REAR of Column
(2)
