(2)
1. Place the Leg (3) on a clean surface. Position the
Modesty Panel (2) next to the Leg with the four slots toward
the floor. Attach the Modesty panel to the Leg with three
Screws (E2) and three KEPS Nuts (E3). DO NOT TIGHTEN
the screws at this time.
2. Install two Glides (E4) into Leg.
3. Turn the assembly to an upright position.
4. Attach the Return Bracket (6) to the previously
assembled furniture. The Return Bracket has mounting
slots for various products. This bracket is used for RIGHT
or LEFT Hand mounting.
Slots in the 'A' position are to be used when attaching Tilt
Return to a Credenza only.
Slots in the 'B' position are to be used when attaching Tilt
Return to a Desk, J-Table or P-Table.
5. Align the slots in the Bracket with the holes in the
underside of the work surface that will place the bracket
approximately 15 1/4 inches from outer edge of the work
surface.
6. Attach Bracket with four #10 x 3/4 Screws (E1). DO
NOT TIGHTEN these screws at this time to allow for
alignment.
3
2
