(2)
Drawer Pedestal Assembly:
1. Remove the Pedestal (5) from carton.
2. Remove all drawers from the Pedestal by pulling drawers out to the
full extent. Locate the drawer slide release tab on each drawer slide.
Press DOWN on the Right tab and LIFT the Left tab. Pull drawer forward
to remove.
3. Turn the Pedestal upside down and install 4 Glides into threaded
holes on bottom of Pedestal.
"J" Table Assembly:
NOTE: Shape, size, and accessories may vary but assembly procedure remains the same.
4. Place the Work Surface (1) face down onto a clean, protected surface.
5. Place Leg (4) in the corner of the Work Surface approximately 3/16 from the edges and align the holes in the Leg
with the pre-drilled holes in the Work Surface. Attach Leg with six Screws (E1). DO NOT tighten screws at this time.
Place Leg (5) at the edge of the Work Surface (Short Side). Notice the position of the extra holes on the side of this
Leg. These holes will be used to join two tables together. Position the Leg approximately 3/16 from the edges and
align the holes in the Leg with the pre-drilled holes in the Work Surface. Attach Leg with six Screws (E1). DO NOT
tighten screws at this time.
Place Leg (6) at the edge of the Work Surface (Long Side). Position the Leg approximately 3/16 from the edges and
align the holes in the Leg with the pre-drilled holes in the Work Surface. Attach Leg with seven Screws (E1). DO
NOT tighten screws at this time.
For units equipped with a Drawer Pedestal (7):
Place Drawer Pedestal (7) at the edge of the Work Surface (Long Side). Position approximately 3/16 from the edges
and align the Pedestal holes with the pre-drilled holes in the Work Surface (NOTE: DO NOT USE keyhole slots).
Attach the Pedestal with four Screws (E1) - two at the front and two at the rear. DO NOT tighten screws at this time.
6. Position the Modesty Panels (2 & 3) between the Legs (Leg and Pedestal). Align the holes in the Panel with the
pre-drilled holes in the Work Surface. Secure Panels to the Work Surface with Screws (E1). DO NOT tighten
screws at this time.
7. Attach the Modesty Panels (2 & 3) to each Leg with three Screws (E2) and three KEPS Nuts (E3) per end.
Modesty Panel does not get attached to the Pedestal Unit.
8. Gussets (9 & 10) are required on the Long Modesty Panel (2) only. Align the holes in the Gussets and the holes
in the Long Modesty Panel. Attach each Gusset with two Screws (E2) and two KEPS Nuts (E3). Attach each
Gusset to the Work Surface with two Screws (E1).
9. Tighten all screws at this time.
10. Install two Glides (E4) into each Leg.
Pedestal
Glide