REV. 05092016
INSTALLATION AND CARE GUIDE
www.maykke.com
INSTALLATION AND CARE GUIDE
INSTALLATION (continued)
2
Installing support for vanity
(see fig 2)
Provide 2x6 backing material behind the finished wall to properly
support the vanity.
□ To properly secure the vanity, the middle of the required
2x6 backing material must be 31-3/16” from the finished
floor.
□ Extend the backing material beyond the width of the
vanity to the nearest stud. This will ensure proper support
for the vanity.
□ Front-notch the studs to ensure the 2x6 backing material
is flush against the studs.
□ Secure the 2x6 backing material to the studs with framing
nails.
□ Rough-in the water supply and drain lines into the rough-
in plumbing areas of the vanity.
3
Attaching the vanity
(see fig 3)
□ Verify the vanity is level and the back rail is
plumb against the wall. If necessary, turn
the leg levelers (AA) to adjust the vanity.
□ Using a drill bit, drill two pilot holes through
the back rail and the finished wall. Verify the
pilot holes are positioned to ensure the lag
bolts will engage the 2x6 backing material.
□ Secure the vanity to the finished wall
with two 5/16” lag bolts and washers (not
provided).
31-3/16”
2”x6” back
ing mat
erial
AA
A
Fig 2
Fig 3
3
Summary of Contents for YSA1001801
Page 13: ......
