MAYBACH COMAND AND REAR-CABIN AUDIOVISUAL SYSTEM, Operator'S Manual

Page: 167 / 319

167
Voice Control System – Front Cabin
Telephone operation
For a complete list of commands
(
page 182).
Telephone
Use the command “Telephone” to acti-
vate the telephone system. Use this com-
mand if you want the digits you are
entering to appear on the main display.
“Help Telephone”
Use the command “Help Telephone” and
the Voice Control System will read out an
option list of available functions and
commands that can be used in conjunc-
tion with the telephone (
page 186).
“Enter unlock code”
Use the command “Enter unlock code”
to input the code to unlock your tele-
phone. After speaking the command,
you are prompted to enter the code.
Speak the code
as a continuously spoken string of
digits
or
in digit blocks of three to five digits.
Digits from “Zero” to “Nine” may be
used. After each digit block (separate the
digit blocks by using an approx. 0.5 sec-
ond pause), the Voice Control System re-
peats the recognized digits and waits
until you continue speaking.
Sample dialog:
“Dial number”
You can dial a phone number using the
command “Dial number”.
Digits from “Zero” to “Nine” may be
used.
The phone number must be spoken
as a continuously spoken string of
digits
or
in digit blocks (three to five digits in
each block).
After each digit block (separate the digit
blocks by using an approx. 0.5 second
pause), the Voice Control System repeats
the recognized digits and waits until you
continue speaking.
When dialing 1-800 numbers, you may
pronounce the first four digits as “One
eight hundred” and the system will rec-
ognize the spoken entries as “One eight
zero zero”. All other numeric entries
must be spoken as individual numbers.
Telephone commands
s
Enter unlock code
t
Enter unlock code
s
Zero zero one one
t
Zero zero one one
s
Save
i
GSM phones only: If the incorrect un-
lock code is entered three consecu-
tive times, the phone card is blocked.
You can unblock the phone card us-
ing the PUK (Personal Unblocking
Key) to unblock the card. The PUK
can only be entered using the keypad
on your telephone (see separate op-
erating instructions for your cellular
telephone).