Mini Massage Gun Hot & Cold Pro
EN
19
3. Press the
button briefly to
switch between the intensity lev-
els. The number of control lamps
lit indicates which intensity level
is currently set.
L
We recommend starting
with the lowest level and
gradually increasing the
level of intensity.
4. Hold the device by the han-
dle (
3
) and guide the attachment
over the area of the body you
want.
Please Note:
Even though the
intensity can be increased with
a small amount of pressure,
you should
not exert too much
pressure
!
L
We recommend that you
do not massage one area
of muscle for longer than
max. 15 minutes in one go.
5. To switch off the device, press
the
button for approx. 3 sec-
onds. The control lamps go out.
CARE AND STORAGE
Please Note!
■
Do not use any caustic or abra-
sive cleaning agents or cleaning
pads to clean the device. These
may damage the surfaces.
Make sure that the device is
switched off and is not connected
to the mains power.
•
Remove the used attachment
from the main unit (
2
) and clean
it. All attachments
apart from
the sphere attachment
(
11
)
and
the heating attachment
(
12
)
can be cleaned with warm water
and a cleaning agent.
•
Wipe down the main unit, the
sphere attachment and the heat-
ing attachment with a slightly
damp cloth.
•
Store the device and all acces-
sories in the storage bag in a dry
place which is protected from
sunlight and is out of the reach
of children and animals.
TROUBLESHOOTING
If the device does not work prop-
erly, check whether you are able to
rectify the problem yourself. If the
problem cannot be solved with the
steps below, contact the customer
service department.
Do not attempt to repair an
electrical device yourself!
The charge control lamp (7) of the
device or the heating attachment
does not light up red when the de
vice or the heating attachment are
connected to the mains power.
The USB mains adapter is not
plugged correctly in the plug
socket or the USB connector is not
plugged correctly in the charging
socket (
6
) of the device or the
heating attachment or in the con-
necting socket on the USB mains
adapter.
►
Correct the fit of the plug
connections.
