MAXXMEE 01935, Manual, Page: 14 / 32

EN
14
Cleaning the Pulse Roller
1. Release the two locking catches ( 9,
13 ) on the cover ( 12 ) with a coin or
another fl at object (note the lock
symbols).
2. Take off the cover.
3. Take out the pulse roller (
11 ).
4. Wipe down the pulse roller and the
compartment with a damp soft cloth if
necessary. Then dry with a soft cloth.
NOTICE: Allow the pulse roller to
dry completely before the device is
reassembled.
5. Place the pulse roller on the motor
shaft and press into the compartment.
6. Place the cover back on. When you
do this, make sure that all four locking
lugs sit in the respective recesses at
the front.
7. Close the locking catches again with
a coin or similar object (note the lock
symbols).
Cleaning the UV-C Lamp
Please Note!
■
The UV-C lamp will become hot
during use. Allow the UV-C lamp to
cool suffi ciently after using the device.
There is a danger of burns!
1. Undo the screw on the cover ( 7 ) of the
UV-C lamp ( 15 ) and take off the cover.
2. Wipe down the UV-C lamp with a dry
duster.
NOTICE: Make sure that you do
not touch the UV-C lamp with your
fi ngers!
3. Place the cover back on and fi x it with
the screw.
Removing the UV-C Lamp
1. Carefully twist the holders on the
sides of the UV-C lamp ( 15 ) until
the slot is pointing upwards and the
contacts are visible.
2. Carefully lift up the UV-C lamp and
pull it out of the holders.
3. Carefully insert a new UV-C lamp and
twist the holders a little so that the
UV-C lamp is fi xed in place.
NOTICE: Make sure that you do not
touch the UV-C lamp with your fi ngers!
Storage
Store the device in a cool, dry place
which is protected from direct sunlight
and is out of the reach of children and
animals.
TROUBLESHOOTING
If the device does not work properly,
check whether you are able to rectify the
problem yourself. If the problem cannot
be solved with the steps below, contact
the customer service department.
Do not attempt to repair an
electrical device yourself!
The device generates no suction.
The mains plug is not inserted in the plug
socket correctly.
►
Correct the fit.
The plug socket is defective.
►
Try another plug socket.
There is no mains voltage.
►
Check the fuse of the electrical
distributor (fuse box).
The device is not switched on.
►
Press the On / Off switch ( 2 ).
Low suction force.
The dust container ( 5 ) is too full.
►
Empty the dust container.
The fi lters ( 1, 6 ) are dirty.
►
Clean the filters.
The suction opening ( 10 ) is blocked.