EN
12
TIPS AND NOTES
• Always clean mattresses on both
sides.
• We recommend cleaning new mat-
tresses once a month. Older mattres-
ses should initially be cleaned every
day for a week. We then recommend
cleaning them once a month.
• The
fi lter should be replaced every
12 – 18 months; the UV-C lamp (
12
)
should be replaced every 12 – 24
months. If you have any questions
about spare parts, please contact the
customer service department via our
website:
www.dspro.de/kundenservice
USE
Please Note!
■
The device should only be used if it
has been fully and correctly assem-
bled!
The dust container and the
fi lter must be inserted and must
not be damaged!
If the dirt were to
get inside the motor unit, this could
damage the motor.
■
Make sure that the safety switches of
the UV-C lamp are not blocked!
1. Insert the mains plug into a properly
installed plug socket that is easily
accessible.
2. Place the device down fl at on the
surface which is to be cleaned.
3. Press the On / Off switch (
1
) to switch
on the device. The device starts to
vacuum and the UV-C lamp (
12
) and
the vibration head (
9
) switches on.
The vibration shakes up the
surface which is to be cleaned
and the dust which is agitated
is sucked in through the suction
opening (
10
).
4. Guide the device very slowly and
evenly over the surface to be clea-
ned.
5. After vacuuming, press the On / Off
switch to switch off the device.
6. Remove the mains plug from the plug
socket.
CLEANING AND STORAGE
Please Note!
■
Empty the dust container each time
after you use the device. The fi lter
must also be regularly cleaned in
order to prevent overloading of the
motor.
■
Do not use any sharp or abrasive
cleaning agents to clean the device
and accessories. They may damage
the surfaces.
■
CAUTION – Danger of Burns!
The
UV-C lamp will become hot during
use. Allow the UV-C lamp to cool
suffi ciently after using the device.
• Make sure that the mains plug has
been pulled out and the device is
disconnected from the power.
• As required, wipe down the motor
unit with a damp soft cloth. Then dry
it with a soft cloth.
• Wipe out the recess for the dust con-
tainer (
4
) with a duster.
Cleaning the Dust Container and
HEPA Filter
1. Reach into the recess in the dust
container (
4
) and pull it up and out of
the motor unit (
3
).
2. Pull the HEPA-fi lter out of the dust
container.
3. Empty the dust container.
4. Wipe out the dust container with a
dry duster if necessary.
