WARNING
Ensure that the LP gas cylinder is kept at a minimum distance of three feet (36 inches) away from
the appliance.
CONNECTION
1. Be sure the cylinder valve and appliance valves are “off”.
2. Place full LP gas cylinder on tank ring bracket. Center the nipple in the cylinder valve and
hold in place.
3. Using the other hand, turn the hand wheel clockwise until there is a positive stop. Do not use
tools. Hand tighten only.
When making the connection, hold the regulator in a straight line with the cylinder valve, so as
not to cross thread the connection.
4. Leak test connection. See “leak test”.
LEAK TEST
1. Do not use or permit sources of ignition in the area while doing the leak test. This includes
smoking.
2. Leak testing should be done once per year or wenever the LP gas cylinder or any other gas
system part is replaced, whichever is more frequent.
3. The leak testing solution should be half liquid detergent and half water.
4. Apply the solution to the LP gas delivery system at points shown in the illustration.
5. Bubbels in the soap solution indicate that a leak is present.
6. The leak(s) must be stopped by tightening the loose joints, if possible, or by replacing the faulty
parts(s) with the part(s) recommended by the appliance manufacturer.
THE APPLIANCE IS NOT TO BE USED UNTIL ANY LEAK IS CORRECTED.
A gas appliance repairman or LP gas dealer should be called if attempts to stop the leak(s) are
unsuccessful and in such case, the LP gas supply must be shut off at the cylinder valve or the cylin
-
der must be removed from the appliance until the leak(s) is corrected.
Inspect hose prior to each use of the unit. The hose assembly must be replaced prior to the appli
-
ance being put into operation if there is evidence of excessive abrasion or wear, or if the hose is
damaged. Contact dealer should you require a replacement hose.
Inspect burner prior to each use. Burner must be replaced prior to the appliance being put into
operation if there is evidence of damage. Replacement burners are available from dealer.
Should any part of this appliance (including the burner) become soiled or dirty, wipe lightly with a
damp cloth. Do not use flammable or corrosive cleaning products on or near this unit.
Ensure that gas hose is placed in an area where it is unlikely to be tripped over (such as pathways
or trails) or subject to other accidental damage.
Keep the appliance area clear and free from combustible materials, gasoline and other flamma
-
ble vapors and liquids.
Solid fuels shall not be burned in this appliance.
Use propane or butane gas only.
The pressure regulator and hose assembly to be used must conform to local standard codes.
The installation must conform to local codes, or in the absence of local codes, with the standard
for the storage and handling of liquid petroleum gases.
A dented, rusted or damaged propane tank may be hazardous and should be checked by your
tank supplier. Never use a propane tank with a damaged valve connection.
The propane tank must be arranged to provice for vapor withdrawal from the operating cylinder.
Never connect an unregulated propane tank to the heater.
- 10 -
- 11 -
Summary of Contents for 21014
Page 2: ... 2 ...
