7
Step 8
Complete the installation by placing any excess
wiring to the inside of the roof opening and sliding
the Garnish Ring into position. Fasten in place
using the four painted flat head screws provided.
A
B
Congratulations
!
You have successfully completed the installation of your new
MaxxFan
.
If there is anything we can do for you, please visit our website
www.maxxair.com
or call us at:
(800) 780-9893
8
Ceiling
Thermostat
Sensor
Garnish
Ring
(Measurements are an example for illustration purposes only.)
NOTE:
Do not probe or tamper with the
thermostat sensor shown in photo #7.
7A
- After adding, in this example, 1/2 inch more,
a line is drawn on the outside of the Garnish Ring
at 4 inches.
7B
-
Connect all four corners with a line at the re-
quired dimension and trim accordingly.
Step 7
The interior Garnish Trim Ring must be
trimmed to fit your particular RV roof thickness.
To accomplish this, measure the distance from the
vehicle ceiling surface to each corner of the
MaxxFan
Control Plate.
Most RV roofs have some slope, so measuring
each corner is necessary. The Garnish ring
should be cut 1/4 to 1/2 inch longer than the di-
mensions measured at each corner.
In the picture (#7) to the left, the installation
measures 3 and 1/2 inches from the ceiling
(example only) to the Control Plate. Go to
7A & 7B.
On Remote Control Models:
Attach provided cra-
dle to wall with (2) #6 screws provided. Handheld
Remote Control may be placed
into wall cradle for storage
