Warning
Any
changes
or
modifications
not
expressly
approved
by
the
party
responsible
for
compliance
could
void
the
user’s
authority
to
operate
the
equipment.
This
device
complies
with
part
15
of
the
FCC
Rules.
Operation
is
subject
to
the
following
two
conditions:
(1)
this
device
may
not
cause
harmful
interference
(2)
this
device
must
accept
any
interference
received,
including
interference
that
may
cause
undesired
operation.
Note:
This
equipment
has
been
tested
and
found
to
comply
with
the
limits
for
a
Class
B
digital
device,
pursuant
to
part
15
of
the
FCC
rules.
These
limits
are
designed
to
provide
reasonable
protection
against
harmful
interference
in
a
residential
installation.
This
equipment
generates,
uses
and
can
radiate
radio
frequency
energy
and,
if
not
installed
and
used
in
accordance
with
the
instructions,
may
cause
harmful
interference
to
radio
communications.
However,
there
is
no
guarantee
that
interference
will
not
occur
in
a
particular
installation
If
this
equipment
does
cause
harmful
interference
to
radio
or
television
reception,
which
can
be
determined
by
turning
the
equipment
off
and
on,
the
user
is
encouraged
to
try
to
correct
the
interference
by
one
or
more
of
the
following
measures:
‐
Reorient
or
relocate
the
receiving
antenna.
‐
Increase
the
separation
between
the
equipment
and
receiver.
‐
Connect
the
equipment
into
an
outlet
a
circuit
different
from
that
to
which
the
receiver
is
connected.
‐
Consult
the
dealer
or
an
experienced
radio/TV
technician
for
help.
SAR tests are conducted using standard operating positions accepted by the FCC
with the device transmitting at its highest certified power level in all tested
frequency bands, although the SAR is determined at the highest certified power
level, the actual SAR level of the device while operating can be well below the
maximum value,Before a new device is a available for sale to the public, it must be
tested and certified to the FCC that it does not exceed the exposure limit
established by the FCC, tests for each device are performed in positions and
locations as required by the FCC.
For body worn operation, this model device has been tested and meets the FCC RF
exposure guidelines when used with an accessory designated for this product
.
or
when used with an accessory that Contains no metal and that positions the device
a minimum of 10 cm from the body.
Non-compliance with the above restrictions may result in violation of RF exposure
guidelines.
Summary of Contents for MX-HUB
Page 1: ......
Page 2: ...Quick Start Guide...
Page 3: ...Note This User Guide provides the basic operations of the MX HUB...
