Maxwell MW-2029, Manual Instruction

Page: 11 / 40

11
ENGLISH
dropped, unplug the unit and apply to any authorized service
center from the contact address list given in the warranty
certificate and on the website www.maxwell-products.ru.
•
Keep the unit in a dry cool place out of reach of children and
disabled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD USE ONLY, ITS
COMMERCIAL USAGE AND USAGE IN PRODUCTION AREAS
AND WORK SPACES IS PROHIBITED.
USING THE HAIR DRYER
After unit transportation or storage at low temperature
keep it for at least three hours at room temperature before
switching on.
– Before switching the unit on, make sure that your home
mains voltage corresponds to the unit operating voltage.
–
Remove any packaging materials that can prevent the unit
operation.
–
Unwind the power cord completely.
– Insert the power plug into the mains socket.
–
Select the required operation mode using the switch (1):
« 0 » – the hairdryer is switched off;
« 1 » – supply of warm air at low flow speed;
« 2 » – supply of hot air at maximal flow speed.
Note: During the first operation some foreign smell and a
small amount of smoke from the heating element is possible,
it is normal.
–
After unit operation, switch the hairdryer off by setting the
switch (1) to the position «
0 », and unplug it.
Overheating protection
Overheating protection switches the hairdryer off if the outgoing
air flow is too hot. If the hairdryer switches off during operation,
set the operation mode switch (1) to the “
0 ” position, unplug
the hair dryer and make sure that the inlets and outlets are
unblocked. Let the hairdryer cool down for 5-10 minutes and
switch it on again. Do not block the air inlets during unit operation
and avoid getting of hair into its air inlet.
CLEANING AND CARE
–
The hair dryer is intended for household use only.
– Set the switch (1) to the position « 0 » and disconnect the
hair dryer from the mains.
– You may wipe the unit body (2) with a damp cloth and then
wipe it dry.
–
Clean the air inlet grid (4) with a brush.
– Never immerse the unit into water or other liquids.
–
Do not use abrasives and solvents to clean the unit body.
IM MW-2029_70x130.indd 11 19.01.2018 17:21:29