1.
Pack contents check
Join the 2 pieces of boom together using the
joining plate, M5 x 20mm screws M5 nuts and
5mm Shake Proof Washers.
2.
3.
Assembly
A. Rear Boom x 1
B. Front Boom x 1
C. Mast x 1
D. Fixing Bracket x 1
E. 10m Coaxial Cable x 1
J. Insulator Cap x 1
K. M5 Nut x 6
L. No.10 1” Screw x 4
M. M5 Screw x 5
F. Dipole x 1
G. 6½ Screw x 1
H. Joining Plate x 2
I. Wall Plug x 4
Screw on firmly the Dipole to the Boom.
Slide on and firmly push down the Reflector onto
the groove of the Reflector Bung.
B
A
J
F
H
N
K
M
A
N. Washer x 2
O. Coaxial Plug x 1
P. Cable Clip x 8
Q. M5 x 35 Bolt x 1
E
C
D
O
P
I
L
G
Connecting Coaxial Cable
1.
Thread coaxial cable through Dipole Cap. Strip
away 25mm of outer insulator. Gather outer braid
strands and twist together. Remove 10mm of
inner insulation around inner core.
Loosen the screws on the 2 terminals in the
Dipole. Feed the inner core to one of the
terminals and the twisted braid into the other.
Tighten screws and close Dipole Cap.
Inner
core
25mm
10mm
Outer
braid
Outer
insulator
Inner
insulator
Foil
2.
Insert Mast into Fixing Bracket. Make sure the
holes in the Mast align with the holes in the
bracket. Insert nuts & bolts as shown and securely
tighten using a 8mm spanner
Mount bracket to a secure solid external wall or
internal wooden beam using the screws and wall
plugs if required. A 6mm drill bit will be required
if using wall plugs.
Mount Installation
Q
