USING YOUR SAT FINDER
Your Sat Finder is used to help you locate and find the best signal quality received from satellites.
Using the integrated sat finder.
Tune the sat finder by turning the knob fully anti-clockwise and then slowly clockwise until a deep
tone is heard and until 2-3 red LEDs are lit. Slowly rotate the dish from left to right until the pitch of
the sat finder tone peaks and more LEDs light up.
You should now have a picture on your TV.
Please note if you have a high tone on your sat finder and receiving no reception, you
may have located a different satellite as the sat finder is unable to distinguish between
different satellites. If this happens, repeat the above process, searching a slightly
different area and dish angle.
Also ensure your receiver box is set to the correct satellite.
Fine tuning using the integrated sat finder.
Once a picture has been found, turn the sat finder down to a
deep tone and finely adjust your elevation and azimuth to
improve your signal and receive a higher tone with more lights lit.
Using the receiver sat finder.
Firstly, ensure your built in sat finder is turned off by turning it
fully anti-clockwise so only the green light shows.
Turn your box onto the correct satellite (OPTUS C1)
and bring up the satellite finder menu. (see receiver instructions).
Slowly rotate the dish from left to right until the signal quality
and intensity increases.
Contact SatPlus by email [email protected] if you require
instructions on how to access your receivers signal finding menu.
Be sure to include the satellite decoder type, eg Foxtel, Austar, SatKing Altech, or Humax
Fine tuning using the receiver sat finder.
Once a picture has been found, bring up the satellite finder menu and finely adjust your elevation
and azimuth controls to improve your signal quality and intensity.
Did you know?
Most receivers have a built in audio tone which sounds when a signal is located.
Please check your receiver instructions.
Use this when you are unable to see your TV screen.
OPTUS C 1
!
12
