Installation
3-8
DiamondMax 10 80/100/120/160/200/250/300GB Serial ATA
All pins are in a single row, with a 1.27 mm (.050”) pitch.
• The comments on the mating sequence in Table 3-1 apply to the case of
backplane blindmate connector only. In this case, the mating sequences
are: (1) the ground pins P4 and P12; (2) the pre-charge power pins and
the other ground pins; and (3) the signal pins and the rest of the power
pins.
• There are three power pins for each voltage. One pin from each voltage
is used for precharge in the backplane blind-mate situation.
• It is optional to terminate any of the V
33
pins. If a device uses 5.0 V, then
all V
5
pins must be terminated. Otherwise, it is optional to terminate any
of the V
5
pins.
• If a device uses 12.0 V, then all V
12
pins must be terminated. Otherwise,
it is optional to terminate any of the V
12
pins.
3.3.4
ATA Bus Interface Connector
On the Maxtor DiamondMax 10 80/100/120/160/200/250/300GB Serial ATA
hard disk drives, the Serial ATA bus interface cable connector is a standard 7-pin
Serial ATA.
To prevent the possibility of incorrect installation, the connector has been keyed.
This ensures that a connector cannot be installed upside down.
3.3.5
MOUNTING
Drive mounting orientation, clearance, and ventilation requirements are described
in the following subsections.
3.3.6
Orientation
The mounting holes on the Maxtor DiamondMax 10 80/100/120/160/200/250/
300GB Serial ATA hard disk drives allow the drive to be mounted in any
orientation. Figure 3-6 and Figure 3-7 show the location of the three mounting
holes on each side of the drive. The drive can also be mounted using the four
mounting hole locations on the PCB side of the drive.
Note:
It is highly recommended that the drive is hard mounted on to
the chassis of the system being used for general operation, as well
as for test purposes. Failure to hard mount the drive can result in
erroneous errors during testing.
Drives can be mounted in any orientation. Normal position is
with the PCB facing down.
All dimensions are in millimeters. For mounting, #6-32 UNC screws are
recommended.
26.10
Summary of Contents for DiamondMax 10 100GB
