13
Servo Test Mode Operation & Display
Servo Mode can provide the Linear, Speed and the Deadband test.
The servo load current should be lower than 500mA
No Battery
ACT
SERVO
POWER
SETUP
LINEAR
SPEED
DEADBAND
Digital
Servo
Speed: S/60
°
Digital Servo
Speed:
0.12
S/60
°
START/ENTER
ESC/STOP
Connect the Servo to the
Data port
on the right side of X6-Plus.
Then press "ENTER" to get the SERVO Mode
LINEAR
SPEED
DEADBAND
Analog
Servo
Pulse: uS
Analog Servo
Pulse:
1499
uS
START/ENTER
START/ENTER
ESC/STOP
START/ENTER
ESC/STOP
START/ENTER
START/ENTER
START/ENTER
LINEAR SPEED
DEADBAND
Analog
Servo
Deadband: uS
Analog Servo
Deadband:
2
uS
START/ENTER
START/ENTER
START/ENTER
ESC/STOP
ESC/STOP
Linearity Test
1. Choose servo property(Analog or Digital)
2. Hold the DEC to scroll through the pulse width to the lowest point. Hold the INC to scroll through the pulse width to
the highest point.
3. Check the servo running smooth or not to get the information of linearity, and search the shake point of damaged
servo.
Speed Test
Every servo has its own responding speed. and after a period of using, the speed will change also. By testing the speed,
we can get information of actual speed and select the servos with similar speed (e.g. CCPM helicopter)
1. Choose servo property(Analog or Digital)
2. Press "ENTER" to run the speed test program. X6-Plus will output 5V DC to turn the servo left and right automaticlly.
Servo speed is displayed on the LCD (Base on 5V DC & 60° turn )
3. Press "STOP" to exit the function.
Dead band Test
Dead band Test can give the feedback of servo sensitivity. Generally, the dead band of normal servos shall be 1uS.
However, because of the precision of servo and assembly, the actual dead band will be different. By testing the dead
band, the actual size of dead band can be defined, which can help you select servos with the same sized dead band.
1. Choose servo property(Analog or Digital)
2. The begining dead band is 0uS. the servo is at the middle position. Press DEC or INC to set the value(1uS/Step), until
the servo move slightly & regularly itself. The value is the dead band.
NOTE: The servo is at the middle position when the dead band value 0uS is setted.
