RF-ROR-135S-319-NN
Wireless Rate of Rise Heat Detector
Rev A
Page 2 of 3
Mounting the Detector
1.
Locate the base mounting holes and mount the
base to the wall or ceiling with the appropriate
hardware (Figure 3)
2.
Attach the detector to the mounting base
Replacing the Batteries
Battery life depends on how often the detector
transmits signals, but is more dependent on the
temperature of the installation environment. When
the battery voltage gets low, the detector transmits
a low battery signal to the panel. The panel then
activates trouble beeps to notify the customer that
the detector battery must be replaced. Pressing the
status button identifies the sensor with the low
battery.
Replace the battery immediately when this
condition occurs, using the following battery:
Panasonic CR123A 3V
Battery Disposal
The batteries used in this sensor are lithium
batteries and are not reusable. Be sure to
properly dispose of used lithium batteries
according to your local hazardous waste
disposal laws.
Specifications
Rate of Rise rating
12° to 15ºF (6.7° to 8.3C)
UL max. Ambient ceiling
100°F/150°F (37.8ºC / 65.6ºC)
Storage Temperature
-30 to 167°F (-34 to 75°C)
Relative Humidity
0 to 95% noncondensing
Maximum UL Spacing
50ft (15.2m) x 50ft (15.2m)
Frequency
319.5 MHz
Expected Battery Life
10 years
Standby Current
Less than 0.9 µA
Supervision Interval
62-68 minutes
Enclosure Dimensions
Diameter: 2.29" (58.25mm)
Height: 1.28" (32.4mm)
Regulatory
UL 521 Heat Detectors for Fire
Protective Signaling Systems
UL 985 Household Fire Warning
System Units
CAN/ULC-S530 Heat Actuated Fire
Detectors for Fire Alarm Systems
CSFM Category 7270
FCC: 15.109 Class B, 15.231
Industry Canada: ICES-003, RSS-
210
FCC / IC Statement
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation.
This equipment generates, uses and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular
installation.
If this equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
Mounting
Holes