Installation & Operation - Junction Box Mounting:
1.
Unscrew the screws on the right side of the fixture
using a suitable Phillips screw driver. Separate the
male and female connectors connecting the driver
DC wires to the LEDs, then remove the reflector
from the back plate.
2.
Depending on the junction box (4" or 5"), drill four (4) 5.0mm holes in
locations indicated by A/B/C/D in the figure below to allow screws to
connect with the junction box. The purpose is to compress the
gasket not weight bearing holding the fixture to the wall. The 3
anchor bolts in # 4 are weight bearing to hold the fixture on the wall.
Unscrew the knockout (KO) plug from the center of the back plate.
3.
Run the main power supply wires from the
water-proof J-box through hole (H), then secure
the back plate to the water-proof J-box using four
(4) #8-32 screws and the four (4) holes drilled in
step 2.
4.
Drill three (3) holes in locations indicated by E/F/G. Fasten the
back plate to the wall with three (3) anchor bolts.
Reflector
Male
Connector
Female
Connector
Knockout (KO) Plug
Back Plate
Electric
Drill
#8-32 Screws Main Power
Hole(H)
Water-proof J-Box
Reflector
Male
Connector
Female
Connector
Back Plate
A
D
C
B
Note:
Add a bead of exterior grade silicone sealant around the perimeter of the wall pack on the wall to inhibit any moisture
from attachment bolts.
© Copyright 2021. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: [email protected]
Page: 2
REV: 11/19/21
Operating Instructions WPOP Series
MaxLite CCT Selectable WallMax™ Open Face
®
E
F
5.
Place the reflector back onto the back plate using
the hinge mechanism. Connect the main power to
the driver according to the wiring diagram. Next,
connect the male and female connectors together.
Finally, use a suitable screwdriver to connect the
reflector to the back plate to seal the fixture.
G
