Installation
Pendant Mount:
1.
Begin by removing the rubber plug shown in
Fig. 1
2.
Next place a lock nut on the threaded pipe at the end where the fixture
will be mounted. Screw fixture onto the pipe.
(Fig. 2)
3.
Pull wires through the pipe and wire as shown on page 2.
Motion Sensor Configuration Instructions
DIP Switch Settings:
1.
Remove lens by unfastening 4 screws with Allen key. (
Fig. 3
)
2.
Remove white cover plate by unfastening 4 screws. (
Fig. 4
)
3.
Choose from the switch settings outlined on next page.
4.
Reassemble white cover plate and lens.
Note:
for manual sensor adjustment only.
© Copyright 2021. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: [email protected]
Page: 3
REV: 12/13/21
Operating Instructions
CPL Series
MaxLite LED Low-Profile Garage & Canopy Luminaire
®
