Maxkon WF-40S, Manual

Page: 3 / 15

3

DO NOT place the heater near a bed because objects such as pillows or blankets can fall off
the bed and be ignited by the heater.

NEVER use this heater in bathrooms, laundry rooms , or any other location where the
heater could fall into a bathtub or pool , become damp or come in contact with water .

AVOID FIRE!
Regularly inspect all air vents to make sure they are free from dust, lint, or other
Blockage. Unplug the unit and clean with a vacuum ONLY . DO NOT rinse or get wet.

ALWAYS mount to wall bracket before use. DO NOT set on the floor, or other surface, to use.

NEVER
use a wall mount bracket from another manufacturer.

This product is not intended to be a primary heat source . It is for supplemental heat only.

INDOOR use only! NEVER use this heater outdoors! Doing so may result in electric shock!

Risk of electric shock ! DO NOT OPEN! No user-serviceable parts inside!

ALWAYS turn this heater off before unplugging it from the outlet.

ALWAYS disconnect this unit from the power supply before performing any assembly or
cleaning, or before relocating the electric fireplace.

NEVER
leave this heater unattended.
ALWAYS
unplug this heater when not in use.

ALWAYS store this heater in a dry location. NEVER use the fireplace if it has become wet.

NEVER plug this heater into an outlet that is old , cracked , or has any loose wires or
connections
. Plugging this heater into a faulty outlet could result in
electric arcing
within
the outlet that could cause the outlet to overheat or catch fire .

ALWAYS check your heater cord and plug connections with each use !
i)
MAKE SURE
the plug fits tight in the outlet! Faulty wall outlet connections or loose plugs
can cause the outlet to overheat.
ii) Heaters draw more current than small appliances. Overheating may occur even if it
has not occurred with the use of other appliances.
iii) During use check frequently to see if the plug outlet or face plate is HOT !
iv) If the outlet or face plate is
HOT
,
discontinue use immediately
and have a qualified
electrician inspect and/or replace the faulty outlets.

The power cord supplied with the heater
has a plug with two flat blades (live and
neutral) . If a 3-slot receptacle is not
available, an adapter MUST be used. The
adapter MUST be properly grounded to
the outlet box (see figure at
right).(Note:Adapter NOT INCLUDED.)

SAVE THESE INSTRUCTIONS!