MINI-MAX
INST
TION
ALLA
WIRELESS
Page 1
30 Barnet Boulevard
New Bedford, MA 02745
(508) 995-2200
THIS MANUAL IS DESIGNED TO LEAD YOU STEP BY STEP THROUGH THE PROCEDURES REQUIRED
TO TEST, INSTALL AND USE YOUR WIRELESS MINI-MAX. BY FOLLOWING THESE PROCEDURES AND
SETTING UP THE SYSTEM CORRECTLY IN THE BEGINNING, YOU WILL BE ABLE TO ENJOY ALL THE
FEATURES OF YOUR WIRELESS MIN-IMAX FOR YEARS TO COME. WE STRONGLY SUGGEST THAT
YOU PERFORM A TRIAL WIRING OF YOUR WIRELESS MINI-MAX PRIOR TO FINAL INSTALLATION.
WHITE
GREEN
RED
WHITE
GREEN
RED
YELLOW
1
Connect the
and
wires from the RECEIVER
to the power terminals on the back of the MINI-MAX (the
polarity does not matter). Connect the wires from the 12 volt
power supply to the same power terminals (again the polariity
does not matter). Connect the
wire from the RECEIVER
to TERMINAL #1 and the
wire from the RECEIVER to
TERMINAL #2 on the rear of the MINI-MAX meter.
BLACK
RED
GREEN
WHITE
2
1
OUT
GND
IN
5
4
3
WHITE
GREEN
RED
MINI-MAX
RECEIVER
12 VOLT
POWER
SUPPLY
RECEIVER WIRING
BROWN
YELLOW
POWER
TERMINALS
YELLOW
GREEN
RED
WHITE
BROWN
WHITE
.............to...............TERMINAL #1
............to...............TERMINAL #2
.................to........Power (no polarity)
............to........Power (no polarity)
.........to......Rainwatch (optional)
...........to......Rainwatch (optional)
BLACK
RED
GREEN
YELLOW
BROWN
BROWN
BLACK
BLACK
Wire the receiver to the MINI-MAX display unit.
2
The MINI-MAX should now show a default temperature
reading of approximately 32 . Refer to the troubleshooting
section if the reading is not approximately 32 .
3
ALKALINE
ALKALINE
BATTERIES
WIRELESS
TRANSMITTER
TEST LIGHT
ALKALINE
Open the battery compartment of the temperature transmitter
by removing the stainless steel screws in the cover. Insert
two Alkaline batteries. The test light in the wireless transmitter
will blink red once to indicate that the batteries have been
installed properly.
