Concrete (reinforced) wall Mounted installation:
Please note, when you use the electric drill, you should wear the eyes
protection goggles.
Step 1:
Take the electric drill and use drill bit to drill a 35mm deep
hole. Then clean the hole.
Step 2:
Take the plastic screw anchors, using hammer to insert the
anchors into the hole.
Step 3:
Take the screws, use screw driver, and screw them through
the fixing holder onto the plastic anchors.
Step 4:
Fix the main unit on the fixing holder.
wall mounted installation with the Velcro tape:
Step 1:
Find the fixing position and make sure the antenna can get a
good signal reception. - The areas where the Velcro tape
should be placed, needs to be clean.
Step 2:
Attach one side of the Velcro tape to the back of the antenna,
and another side of the Velcro tape to the position you want to
fix the antenna.
Step 3:
Fix the main unit to the position.
TRoUBLE SHooTING
1�
If you can not get the digital programs as you expect, please check
the following conditions:
a�
Check the connections. Make sure all connections are correct.
b�
Check the antenna power function of your receiver. DA-6 is an
active antenna. You will need to enable the antenna power
function. (Please check the manual of the receiver or TV.)
c�
If you place the DA-6 antenna on the TV panel, please try to
move the antenna away from the TV panel. Some panels can
reduce the signal reception.
2�
Adjust the direction and position of antenna
to find the best reception angle.
3
GB - English
USER MANUAL
Summary of Contents for DA-6
Page 20: ......