WARNING!
To avoid serious personal injury from unexpected tool
movement, always secrurely mount scroll saw to a workbench.
WARNING!
If any parts are damaged or missing do not operate this tool
until the parts are replaced. Use of this product with damaged
or missing parts could result in serious personal injury.
• Do not attempt to modify this tool or create accessories not
recommended for use with this tool. Any such alteration or
modification is misuse and could result in a hazardous
condition leading to possible serious personal injury.
• Do not connect to power supply until assembly is complete.
Failure to comply could result in accidental starting and
possible serious personal injury.
• Risk of injury! Always pull out the mains plug (disconnect
the product from its power supply) before commencing
work on the product.
UNPACKING
Do not use this product if any parts of the package contents are already assembled to
your product when you unpack it. Package contents are not assembled to the product
by the manufacturer and require customer installation. Use of a product that may have
been improperly assembled could result in serious personal injury.
•
Inspect the tool carefully to make sure no breakage or damage occurred during
shipping.
•
Do not discard the packing material until you have carefully inspected and
satisfactorily operated the tool.
17
ASSEMBLY
16
ASSEMBLY
•
The scroll saw is factory set for accurate cutting. After assembling it, check for
accuracy. If shipping has influenced the settings, refer to specific procedures explained
in this manual.
•
If any parts are damaged or missing, please call 1-888-670-6682 for assistance.
PACKAGE CONTENTS
TOOLS NEEDED FOR ASSEMBLY
No.
Description
Qty Illustration
Scroll saw assembly
Rubber feet
5mm Hex key
1
2
3
Screwdriver
Right angle ruler
Star-head screwdriver
Wrench
1
4
1
MOUNTING SCROLL SAW TO WORKBENCH (Fig. 2)
If the scroll saw is to be used in a permanent
application, we recommend that you secure it in a
permanent location such as a workbench. When
mounting the saw to a workbench, holes should be
drilled through the supporting surface of the
workbench.
•
Insert one rubber foot (1) into each hole (2) of
the base.
•
Each hole in the base of the saw should be
bolted securely using hex bolts (3), locking
washers (4) and hex nuts (5) (supplied). Bolts
should be of sufficient length to accommodate
the saw base, washers, nuts and the thickness of the workbench (6).
Fig. 2
3
5
4
6
1
2
model no. 055-6706-6 | contact us 1-800-689-9928
model no. 055-6706-6 | contact us 1-888-670-6682
Summary of Contents for 055-6706-6
Page 1: ......
