model no. 054-3224-2 | contact us 1-888-670-6682
20
21
FASTENING WITH SCREWS
This procedure will enable you to fasten materials together with your tool without
stripping, splitting or separating the material. (Fig. H)
First, clamp the pieces together and drill the first hole 2/3 the diameter of the screw. If
the material is soft, drill only 2/3 the proper length. If it is hard, drill the entire length.
Second, unclamp the pieces and drill the second hole the same diameter as the screw
shank in the first or top piece of wood.
Third, if flat head screw is used, countersink the hole to make the screw flush with
the surface. Then, simply apply even pressure while driving the screw. The screw
shank clearance hole in the first piece allows the screw head to pull the pieces tightly
together.
RUNNING NUTS AND BOLTS
Variable speed control must be used with caution for driving nuts and bolts with socket
set attachments. The technique is to start slowly, increasing speed as the nut or bolt
runs down. Set the nut or bolt snugly by slowing the tool to a stop. If this procedure is
not followed, the tool will have a tendency to torque or twist in your hands when the
nut or bolt seats.
OPER
A
TING
INS
TRUCTIONS
(Fig. H)
FASTENING
WITH SCREW
S
1. Drill 2/3 diameter
and 2/3 length for
soft materials, full
length for hard.
2. Drill same diameter
as screw shank.
3. Countersink same
diameter as screw
head.
2. Screw.
Apply a slight even
pressure when driving
screws.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to
damage from various types of commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
BATTERIES
The battery pack is equipped with lithium-ion rechargeable batteries. The duration of
use from each charge will depend on the type of work performed.
The batteries in this tool have been designed to provide maximum trouble-free life.
Like all batteries, they will eventually wear out. Do not disassemble the battery pack
or attempt to replace the batteries. Handling of the batteries, especially when wearing
rings and jewelry, could result in a serious burn.
To obtain the longest possible battery life, read and understand the operator’s manual.
• It is good practice to unplug the charger/adapter and remove the lithium-ion
battery pack when not in use.
FOR LITHIUM-ION BATTERY PACK STORAGE LONGER THAN 30 DAYS:
• Store the lithium-ion battery pack where the temperature is below 79 °F (26 °C) and
free of moisture.
• Store lithium-ion battery packs in a 30–50% charged condition.
• Every six months of storage, fully charge the lithium-ion battery pack.
• Exterior may be cleaned with a cloth or soft non-metallic brush.
MAINTENANCE
WARNING!
• To avoid serious personal injury, always remove the battery
pack from the tool when cleaning or performing any
maintenance.
• When servicing, use only identical replacement parts. Use
of any other parts may create a hazard or cause product
damage. To ensure safety and reliability, all repairs should be
performed by a qualified service technician.
• It is not recommended to use compressed dry air to clean
the driver. If cleaning with compressed air is the only method
available, always wear safety goggles or safety glasses with
side shields when using compressed air to clean the tool. If
the operation is dusty, also wear a dust mask.
• Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc. to come in contact
with plastic parts. Chemicals can damage, weaken or destroy
plastic which may result in serious personal injury.
Summary of Contents for 054-3224-2
Page 1: ......
