Maxi Comet Executive Exec-56-G, Instruction Manual

Page: 53 / 244

Comet Executive Gas Operating Guidelines
3-11
7. If the jammed flatwork cannot be removed
easily:
a) Announce the unit is being started.
Make sure everyone is a safe distance
away from the unit.
b) Press the JOG REVERSE button and
jog the unit briefly, then pause 2-3
seconds before jogging the unit again.
c) Continue jogging the unit in brief in-
crements until the jammed flatwork can
be safely and easily removed.
d) Do not start the unit until the jam is
cleared.
NOTE: If jamming occurs
regularly, tell the maintenance or
service people so they can fix the
problem.
Shut-Down
The following steps are suggested for shutting
down the unit at the end of each day:
1. Turn the TEMPERATURE control dial
to OFF.
2. Turn the SPEED CONTROL knob to the
slowest speed.
3. Allow the unit to run for approximately
20 minutes to cool down.
4. Stop the unit by pressing any of the red
safety STOP buttons.
5. Turn power OFF at the main disconnect
switch.
WARNING
Never leave the unit
unattended without first
following the Shut-Down
procedure above.
Temporary Shut-Down
At times it is necessary for operators to shut
down the unit for a short time. The following
steps are suggested for temporarily stopping
operation.
1. Turn the TEMPERATURE control dial
to OFF.
WARNING
Never leave the
unit unattended while
it is running.
2. Turn the SPEED CONTROL knob to the
slowest speed.
TOC INDEX