Position Locking
Clip
Position locking clip
about 1 in. (2.5 cm)
from vehicle belt’s
latch plate.
Rebuckle vehicle belt.
5.
Attach Locking Clip
Thread both portions
of the vehicle belt onto
the locking clip, as close
to the latch plate as
possible.
4.
6.
Check Vehicle Belt
Tightness
Grasp the base at the
vehicle belt path
with
one hand. Push and pull
the base from side to
side, forward and back.
The base should not
move more than 1 inch.
NOTE:
If base moves more than 1 inch, redo all of the
steps or try another seating location.
Remove the locking clip when the vehicle seat belt
is not being used with a child restraint.
D. General Vehicle Installation
21
22
This base is certified
for aircraft use.
Use only on forward-
facing aircraft seats.
Follow instructions for
vehicle installation.
Contact the airline for their specific policies.
D-6
Installing on Aircraft
D-7
Storing LATCH System
Failure to securely store the LATCH
system can result in serious injury or
death.
Store LATCH By
Connecting the
LATCH Connectors
to Side of Base as
Shown
