©
2008 Maxford USA www.maxfordusa.com
8
8
c) You have 2 pieces of metal snap-hooks in the accessories bag. Those will be used to
tie to each wire and connected to rudder servos arms.
d) Install the rudder servo into the fuselage, line snap hooks to the outer most holes in
the servo arm.
e) Center the rudder servo, then attached servo arm with control lines to the servo.
f) Tighten and adjust the length of the control line if necessary, then crimp tubes over
the lines.
Elevator
There is a carbon fiber push rod with re-bended metal stick on each side in the box. The
length is perfect, just slide it into the fuselage from the tail side, then connect it to the
elevator control horn and servo arm.
Wing and Landing Gear
1. Attach 10” extension cable to the servo cable, use Extension Safety Clip to hold the
connection. There is a leading wire in each servo tray, tie it on the end of extension
cable, pull the wire to lead the cable out of the wing.
2. Connect 2 servo extensions to a 6” Y Harness, use Extension Safety Clip to hold the
connection.
3. Install aileron servos, control horns and push rods.
4. Remove the screw on the main landing gear, then it become to 2 pieces as below
picture. Put the small square wood piece to the U shaped strut, then slide it into the
tray. You have the option to glue the wood piece with the wing. If you decide to do
so, you may not be able to uninstall the landing gear. Apply the long square shaped
metal piece to the strut, use 2 screws to hold it.
